The product has just been received, you must first turn on the flashlight to discharge, and then charge the product for more than 4 hours, and then start the car, because the product is empty. This operation can prolong the service life of the product!
Do not discharge and charge at the same time.
pay attention to this note:
1. Please charge after receive jump starter.
2. Charge every 3 months, low power may fail start.
3. Charge phone tablet only occasionally. efficiency is about 50%.
4. The charge speed or discharge speed will be fast during the last 15% power of the jump starter.
Please do not worry about these problems. This is the characteristic of high-rate lithium batteries, and it will not affect product quality and normal use.
5.The product has just been received. Please turn on the flashlight to discharge it first, then charge the product for more than 4 hours before starting the car, because the product contains virtual electricity. This operation can extend the service life of the product!
Why it's necessary to get a jump starter?
1. Long standby time run out battery;
2. Make preparation for a long driving trip;
3. Your car can't start due to low power or freezing winter;
4. Charging electronic devices such as mobile phones, computers, cameras, etc
5. Works for Pickup,Sports car,Truck,Tractor,Motor,Lawn mower,agricultural machinery, yachts so on
6. DC 12V output port function; Can supply power to 12V equipment such as outdoor refrigerators and ventilators
Description:
1. LED Light (SOS/Lighting/Strobe)
2. Work Light indicator
3. Work in -40℃~85℃ (-4℉~140℉)
4. DC 12V output port function
5. Input: 5V/2A
6. Output: 5V/2A 12V
7. Input Interface: USB-C
8.Material:ABS
9. LED Light: yes
Peak 600A Applicable: 3.0L gasoline vehicles
Peak 1000A Applicable: 3.0L gasoline vehicles
Peak 1200A Applicable: 4.0L gasoline vehicles, 2.0L diesel vehicles
Start steps Simple operation:
Step1. Insert the clip into the power starter port, note that you need to press the clip all the way into the starter port.( More than 75% of power is recommended)
Step2.Red clip connection car battery positive+
Black clip connection car battery negative level-
Step3.Go back to the car and start the car
Step4.Remove the clip after starting (It is recommended to remove it within 20 seconds )
Car Emergency Starting Power Supply
Start with power loss,just hit it
Car Loses Electricity What Should I Do If It Cannot Be Started?
Are you still using the old method?
Manual cart
Find someone to call
Call a tow truck
Powerful Jump Starter For Fuel Vehicles
Powerful and high-rste battery exclusely
designed for jumpstarting most cars
1200A Car Jump StarterCar Jump StarterA Car Jump Starter
Diesel And Gas Dual Start
12V Cars Have No Limit On Displacement
Gasoline 12V/4.0L
Diesel 12V/2.0L
No Limit To Displacement
Applicable To Various Models
Car/SUV/Business car/Forklift
Motorcycle/Van/Pickup truck/Minivan
Start At Low Temperature
Not Afraid Of Severe Cold
Intelligent power management,explosion-proof
and high temperature resistance
80℃
The temperature inside the car is
high in summer,so you can adapt to
the environment and not be afraid of
the high temperature in summer.
-40℃
It can also be used normally
in the severe cold areas of the
north in winter.
Power Bank
Upgraded version
12V output
LED Emergency Lighting
Travel With Confidence At Night
In dark environments,it can provide long-term
lighting,and can turn on the rescue mode in crisis situations.
100A Car Jump Starter
Safety Bold Clip
DO Anti-reverse Connection
Thickened wire core,safe and stable
Vehicle Starting Steps
First step
Connect emergency power supply
Connect the battery tongs to the powerrecs Interface connection
and plug fully into the port
Step two
Connect the car battery
Red clamps,positive clamps,black clamps
negative clamps,positive and negative
electrodes of old batteries if the connector
is severely oxidized,the oxygen must
be removed first,the chemical layer scraped off and then clamped,
Step three
Start the car
Enter the vehicle and start the vehicle.
Step four
Remove the
battery clip
It needs to be removed within 30
seconds after startup
emergency supply.
