Used:
-bedroom , playroom , apartment, kids room, girls room, cupboard, floors, cabinet, enterway, backdrop, countertop,kitchen counter, craft, bedroom counter, christmas decor, wrapping, backsplash, pantry, shelves, Walls, bedside table, nightstand, wardrobe, accent wall, dresser drawer, closets, TV stand, vanity, window privacy, craft, book cover, bulletin board, desk cover, door, window etc.
-Kitchen, Bathroom, Bedroom, Living room,College, Dorm room, Farmhouse, Industrial, Playroom, Cabin, Cubicle, Lake house, Laundry room, Entryway, Office decor etc.
Make sure the surface to be covered is cleaned, dry,
and free from grease. If the surface is rough or uneven,
rub it over with sandpaper to smooth and level it
Measure the length and width of the surface to be covered,
If the surface shape is complex one, sketch a rough outline
of it in a notebook and write measurements for each part
of the outline on your sketch.
Smooth the wallpaper flat and make sure it will fit the surface properly,
free one corner of the backing paper,then pull more backing paper free
until expose around 1/4 inch of backing.Press the 1/4-inch wallpaper
against the surface you wish to cover. Work slowly from one corner of
the strip to the other.
Gently pull the rest of the 1/4-inch paper.Take your time to get this right.
Working from side-to-side to keep the paper smooth,flatten out wrinkles
and expel any air that might get trapped and form a bubble. If wrinkles
and bubbles do occur,gently tear the wallpaper free and try again.
Continue drawing off the backing and smoothing until the whole surface has been covered. Trim off any excess wallpaper
Installation guide come packed with wallpaper roll. Kindly unpack it carefully.
It is 15.8 inch wide. If the surface going to be covered is wider. please kindly overlap the edge of wallpaper to cover whole item, the seam is invisible.
Incorrected installation would form bubbles or wrinkles, please take your time to install, If wrinkles and bubbles do occur, gently tear the wallpaper to try again, really can't avoid it, please use a small pin to poke the bubble and smooth down from edge toward hole.
Textured walls' dips, holes, and gaps reduce the surface area that can contact the wallpaper. The wallpapers will fall down easier than on flat walls, please read below tips before stick-on textured wall: 1. Sand your walls into smooth & dust-free before stick on wallpaper. Or 2. Spray 3M adhesive(or liquid paste) to fill in the gaps & other low spots on wall to make sure sticky wallpaper good attached to your walls.