Item specifics

Condition: New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. See all condition definitionsopens in a new window or tab

Brand: Unbranded

Material: Plastic

Type: electric cutting machine

Length*width*height: 18*15.5*23cm

Origin: Mainland China

Model: Hot cutting machine

MPN: Does not apply

Power: 150 watts

Power cord length: 1.2 meters

Item description from the seller

Adjustable temperature electric cutting machine tape cutting machine fusing machine nylon satin webbing elastic band.

Model: Hot cutting machine

Model net weight: 4.3 kg
Length*width*height: 18*15.5*23cm
Power cord length: 1.2 meters
Voltage: 170-220V
Power: 150 watts

1. Blade temperature
It can reach 500-700 degrees within a few seconds after the product is turned on, and the cutting effect of the belt is particularly good. This belt cutting machine is suitable for cutting
Webbing, rope, elastic band, nylon, etc., heating and consolidating the cut of the webbing will not produce burrs. The product has been widely used
Has passed the inspection and quality assurance of the relevant state departments.
2. How to use:
1. After turning on the power, turn the knob at the bottom right to "1" and wait a few seconds for the blade to turn red to work.
2. When the knob is adjusted to "1", if it is not red enough, it can be adjusted to "2". If it is not red enough, check if the voltage is positive.
Normal (usually around 200V), if the voltage is normal, the user must check whether the blade is in bad contact (details are as follows)
Narrative). If the voltage is too low (below 220 volts), you can continue to increase it to "3" or "4".
3. Main parameters:
Knife
Input voltage: 170-220V
Power: 150W+-15
Four, troubleshooting
1. If the fire is not red enough, please tighten the gong female of the upper blade.
emery cloth
2. After using for a period of time, the heat of the blade will decrease. Remove the blade and wipe both ends of the blade with emery cloth (contact the upper gong)
Silk part) Then tighten the gong with a small wrench.
3. After use, the blade is not red enough or not hot at all the next time it is used. Remove the blade and clean the knife with emery cloth.
Use a small wrench to tighten the gongs at both ends of the slice.
4. If the indicator light does not light up and the fuse is burned out, please replace the 2A fuse. If it continues to burn, please fix it.
Special note: The blade does not burn, but it can be used. Use method four or method two to solve it.