eBay

Green Dot Laser Bore Sight .22 to .50 Collimator Sighter Outdoor Hunting Rifle

Product Feture1. Material: high-quality aluminum, light weight and durable.
2. Features: simple operation, higher stability, no need for preheating. The product has been reset to zero, no adjustment is required, plug and play, accurate and fast.
3. Note: Do not install the battery upside down

ParameterName: Red laser sight
Colour: Black
Light color: Green
Output power: less than 1mW

Wavelength: red light 650nm

Use battery: 1*14250 battery

Adapter: 8 adapters (supports 4.5、5.5、6、8、9、10、14、16mm)
Suitable for: .22 to .50 caliber

Package includes：

1x Green Laser Sight
8x Adapter

1x Screwdriver

1x Wrench

1x 14250 Battery

1x Charger

How to use:

1. Measure the inner diameter of the pipe. Choose the appropriate adapter (8 small adapters).

2. Use a cross screwdriver to screw the adapter onto the rear end of the sight tube.

3. Make sure that the sight itself is straight. Be sure to tighten the battery compartment and the switch, so that the sight will be straight.

4. Tighten the adapter, fully insert the thin tail tube into the pipe, making sure that the front of the switch is facing upward during insertion.

5. Once the mechanism is secured, you can proceed to calibrate it with the sight or scope. Adjust the scope reticle until it becomes parallel to the dot of the collimator. The sight is now accurate.

Fine Tuning:

1. When calibrating the laser to your product, it is best to apply some lubricating oil on the plastic parts (cooking salad oil can also be used as a substitute).

2. The front of the switch must always face up.

3. If there is a mismatch with your product during use, there are four screws on the laser head that can be adjusted.

For example, if the laser dot needs to be adjusted to the left, slightly loosen the screw on the left and then slowly tighten the screw on the right until you see the laser dot move to the desired position.

Store Categories