Model: 321
Collet: 1/2"
Clamping capacity: 1.0mm-13.0mm
No load speed: 0-700RPM
Operating Air Pressure: 90psi
Air consumption: 4.0CFM
Net weight: 1.34KG
Recommendations for using air tools:
◆ Before and after daily use, please fill in 2-3C.C. of #60 pneumatic lubricant (clothespin oil).
◆Please run the compressor freely for a few seconds after oil injection.
◆General traditional air compressor, air compressor compression out of the gas source most of the gas contains water, and air compressor piston lubricating oil brought out of the air compressor, if you do not use the oil-water separator, water and oil with the gas into the pneumatic tool, will make the wind blade stick, the tool will not be able to shake the blade together with the movement, may not start, if it can be started will be into the torque is not enough, be sure to pay attention to the back air inlet from the air intake injection of pneumatic oil then press the button Pneumatic tools can be idle for a few seconds, the torque can return to normal.