JAWEL PAINTS

WHERE THE BEST COSTS LESS

2.5 Litre Slow Low Bake Thinners Suitable for: 2k 2 Pack Paint - Primer & Clear Coat 

      

 PAINTERS’ APPLICATION GUIDE AT THE BOTTOM OF THIS PAGE

Please Note when comparing prices all our paint and materials are Automotive Quality approved, not to be compared with other companies selling cheap industrial paints as automotive paint. Most of the paint we sell is supplied by: Octoral / Valspar and Pro-Spray. the original paint suppliers to most car manufacturers We are one of the largest independent suppliers of automotive paint in the UK and have been trading for over 50 years.

SHOP AND PAY ONLINE COLLECT FROM YOUR LOCAL JAWEL SALES OUTLET

Jawel sales outlets: 

COVENTRY Unit 6 Hanford Close, Stoney Stanton Road, Coventry, CV6 5TL Tel: 02476 665502

ERDINGTON 285 Slade Road, Erdington, Birmingham, West Midlands, B23 7JX Tel: 0121 377 6080

BIRMINGHAM 1082 Pershore Road, Ten Acres End, Stirchley, Birmingham, B30 2YG   Tel: 0121 471 3355

TAMWORTH Unit 17 Beauchamp Ind Estate, Watling Street, Tamworth, Staffs, B77 5BZ Tel: 01827 261553

WOLVERHAMPTON  336-338 Cannock Road, Wolverhampton, West Midlands, WV10 ORB  Tel: 01902 736411

SMETHWICK Units 313-317 Heath Street, Smethwick, West Midlands, B66 2QY Tel: 0121 5586191

BROMSGROVE  53B Sherwood Road, (next door to Greggs opposite Morrisons) (Aston Fields, Bromsgrove. B60 3DR   Tel: 01527872139 

         Jawel Opening Hours: Mon-Friday 9.00am - 5.00pm Sat 9.00am -12.00pm 

Deliveries: Orders placed before.3.00 pm. are dispatched on the same day on a 2-day delivery service and in most cases they are delivered the next day (Monday - Friday only). IT IS IMPORTANT THAT YOU CHECK the contents of your consignment before you sign the carrier’s delivery note - they will not accept any responsibility for damaged goods once they have been signed for. We offer FREE fast delivery service to most UK mainland addresses we cannot send paint or flammable liquids via Royal Mail; we have to use special licensed carriers and unfortunately, they apply a surcharge to the following Post Codes: All IV - All KW - KA 27 to 28. PA (20) (34) 37 to 39 & 41 to 88. PH 19 to 41 and 49 to 50 Sorry we do not ship goods to: Channel Isles ? Isle of Man and Isle of Wight.  If you would like a quote before your purchase, please Phone: 0121 558 6193    

                          PAINTERS GUIDE ON PREPARATION AND APPLICATION

2K ACRYLIC PAINT - 2K PRIMER & 2K CLEAR LACQUER

PREPERATION

(1) Remove any rust and treat with Ferrozinc rust cure.

(2) Primer any bare metal with self-etch primer.

(3) Where body filler is applied make sure you do not overlap on to existing paintwork

(4) Flat with 600 grit wet/dry paper or 400 grit DA discs remove any dust with a blow gun, then wipe the surface with a tack cloth before you use pre paint wax & grease remover.                                                                                          

2K ACRYLIC PRIMER

(5) Mixing ratio: 4 parts primer 1-part 2k Hardener then add 10-15% 2k Thinners to total volume mix this can vary depending on the spray gun setup. Stir Well only mix the amount of material you intend to use in one application.

(6) Apply a cover coat and leave for 10-15 minutes depending on temperature / weather conditions then apply a second coat. When dry sand the primer with fine wet/dry paper 600 or 800 grit. Remove and dust with a tack cloth. Avoid leaving primed surface overnight in a damp workshop, primers are porous so will absorb moisture resulting in poor adhesion.

PRE-PAINT

(7) Prepare workshop ready to apply topcoat. Dampen the floor and if possible, earth the car to stop static. We strongly recommend you wear hooded overalls and use the correct protection: face mask - gloves & overalls only use 2k materials in a well-ventilated workshop or spray booth (see Health and Safety data on our website:  www.jawel.co.uk

2K PAINT APPLICATION

(8) It is most important to STIR PAINT WELL AND CHECK COLOUR. Mix the paint 2 parts paint 1-part 2k hardener then add 10% 2k thinners to volume, this may vary depending on spray gun setup. Apply a light cover coat of paint, leave for 10-15 minutes, depending on conditions, 2K Paint and Clear Coats are direct very high gloss materials when applied correctly,

(9)  If you need to cut and polish, we recommend you leave overnight and then use the new Diamond Cut 3000 liquid compound. Runs in paint or clear coat can normally be flatted out. I have found the best way is to use 1500 or 2000 grit wet / dry paper rub on a bar of soap and lightly flat the run. Do not try and flat out in one application, lightly flat then leave for a couple of hours or longer if possible and repeat the process again taking it away in stages before compounding / polishing.

THIS IS ONLY A BASIC GUIDE, IF YOU REQUIRE MORE INFORMATION, PLEASE

VISIT OUR WEBSITE www.jawel.co.uk FOR MANUFACTURES HEALTH AND DATA SHEETS

IMPORTANT NOTICE REGARDING SOLVENT BASED PAINTS. Please note it is against the law to use non-compliant solvent based paint and materials for refinishing/restoration of motor vehicles , unless the vehicle is classified as vintage (over 30 years old) or classic exceptions: 1) Non-compliant vehicle paint/materials manufactured before 1 January 2007 can still be sold and purchased until stocks have depleted  2) To avoid the environmental consequences of disposing of non-compliant materials DEFRA and the Welsh assembly granted permission (August 2007)  for Auto body repair/refinishing garages to use non-compliant materials they have in stock.  We can supply a full range of compliant materials to suit all of our customers’ Requirements including Water Based paint. Non-compliant solvent-based paint will still be available for customers spraying industrial plant and machinery only. We have a massive colour range including British Standard - RAL and most car, commercial and motorcycle colours.