Reversing Camera Input

1.This car stereo system supports video input, can be connected with rear camera. It automatically changes to reversing view while backing & parking your car.
2. Include a backup camera,12 LEDs and IP68 waterproof.
3.Easy operation and wiring, easy operation and help driver a safe and easier parking.

Camera Wiring:

1.Power cable: black wire connect to negative battery, red wire connect to the positive battery.
2.Reverse trigger wire (pink wire) labeled "reverse or back in" connect to car\\'s reverse light positive.
3. Camera video signal input plug to port on the back of car radio: CAMIN  

Important notice before installation: 
1. Red line pick the key to the ACC line, this line is also positive, control power switch. Black wire connected to the negative power supply.
2. Blue line connected lift the antenna or subwoofer REM control line, if not have do not connected, wrapped up with rubberized fabric.
3. The remaining eight wires(gray white green purple) are speaker line, a group of colors corresponding to a pair of speaker lines (positive and negative).
4. Please pay attention to check whether the original car speaker cable if contact iron (the original car speaker wire welding to the metal, or a speaker only a line thow out, called contact iron). contact iron will cause our high-power machine without sound, please test it with a multimeter before install, if contact iron, please disconnect and then install.
 
Friendly Reminder:
1. Can not use the original car plug directly connected to our new machine, do not match will lead to the machine burned, part of the machine can be shared please consult customer service.
2. If you buy a 12V voltage product do not install to 24V voltage models, otherwise it will cause the machine burned.
3. When wiring, speaker cable and power cord together, will cause a short circuit, lead the machine burned/unable to boot or machine without sound.
Note: This machine is 12V machine, not according to the 24V power supply