Fitment:
SCION TC 2011-2016
SCION XB 2008-2015
SCION XD 2008-2014
TOYOTA CAMRY 2007-2014
TOYOTA COROLLA 2009-2017
TOYOTA FJ CRUISER 2012-2014
TOYOTA HIGHLANDER 2008-2013
TOYOTA MATRIX 2009-2013
TOYOTA PRIUS C 2012-2018
TOYOTA RAV4 2006-2017
TOYOTA SEQUOIA 2008-2018
TOYOTA TACOMA 2012-2015
TOYOTA TUNDRA 2007-2017
TOYOTA YARIS 2007-2018
 

Position:
Rear left/Rear right
 

Package Included:
1 x Window Switch

How To Replace Window Switch

1. Prepare tools: You need a Phillips screwdriver, a 10mm wrench and a plastic pry bar.

2. First, locate the control panel of the door lifter. Usually it is located on the front or rear of the armrest inside the door.

3. Use a screwdriver and wrench to remove the screws securing the control panel. This screw is usually 10mm.

4. After removing the screws, carefully pry open the control panel cover to separate it from the door lining.

5. Next, locate the screws on the lifter motor and remove. This screw is usually on the bottom of the motor.

6. After removing the screws, pull out the wire connector connected to the motor. These connectors usually come in the form of plugs that can be disconnected by simply pulling them back slightly.

7. At this point, the entire window lift switch has been removed. If parts need to be replaced, you can start installing the new parts. Just follow the disassembly sequence in reverse order.

8. Reconnect the wire connector and secure it to the motor. Make sure all connectors are connected correctly to their respective locations.

9. Put the lift motor back into place and tighten the screws at the bottom with a screwdriver and wrench.

10. Reinstall the control panel cover onto the door lining and secure it in place with a plastic spudger.

11. Finally, use a screwdriver and wrench to tighten the screws on the control panel.

    Now, the window lift switch has been successfully replaced or repaired. When performing these operations, make sure the vehicle is turned off and stationary to prevent accidents.