Suitable for :For Fms fcx24m
Scale: 1/24
This product needs to be matched with our Discovery light set. In order to match the lighting.
About Installation. Remove the two fixing screws of the original front bumper. Put the product into the original front bumper position, roughly determine the location of the alignment holes. Then you need to open two holes for wiring, two millimeters in diameter. The terminals are not installed at the factory. This is to make it easier to install the wiring afterward. You can reduce the size of the hole.
About wiring. After the product's light wire hole is opened. Pass the light wire through the front face of the car shell, and then put the spare terminal back into the bag. Pay attention to the positive and negative terminals when installing the bag.
If you are not sure, please refer to the installation method of the other y-wire terminal provided with the product.
After installing, plug the y-cable into the white connector of the front and rear lights of the Land Rover Discovery, and then the connector will become two ports, one for the dome light and the other one for the front bar light.
If you don't understand, you can refer to the last two of the detail pictures.
Products include:
1* Lights with lights front bumper
