98350/98788 Timken Tapered Roller Bearing Cone&Cup Timken 98350 - 98788 SET 373 USA

This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure 

Specifications

Series

98000

Cone Part Number

98350

Cup Part Number

98788

Design Unit

Inch

Cage Material

Stamped Steel

Dimensions

d - Bore

3 1/2 in88.900 mm

D - Cup Outer Diameter

7.874 in200 mm

B - Cone Width

1.9375 in49.213 mm

C - Cup Width

1.3750 in34.925 mm

T - Bearing Width

2.0772 in52.761 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius10.14 in3.600 mm
r - Cup Backface "To Clear" Radius20.130 in3.30 mm

da - Cone Frontface Backing Diameter

4.41 in112 mm

db - Cone Backface Backing Diameter

4.65 in118 mm

Da - Cup Frontface Backing Diameter

7.41 in188.00 mm

Db - Cup Backface Backing Diameter

6.85 in173.99 mm

Ab - Cage-Cone Frontface Clearance

0.24 in6.1 mm

Aa - Cage-Cone Backface Clearance

0.31 in7.9 mm
a - Effective Center Location30.05 in1.3 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)428100 lbf125000 N
C1 - Dynamic Radial Rating (1 million revolutions)5108000 lbf482000 N

C0 - Static Radial Rating

117000 lbf519000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)630400 lbf135000 N

Factors

K - Factor70.92
e - ISO Factor80.63
Y - ISO Factor90.95

G1 - Heat Generation Factor (Roller-Raceway)

203.4

G2 - Heat Generation Factor (Rib-Roller End)

37.5
Cg - Geometry Factor100.120
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Negative value indicates effective center inside cone backface.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 Geometry constant for Lubrication Life Adjustment Factor a3l.