COMPLETE ENGINE FASTENER KIT FOR YAMAHA BLASTER 200cc ATV
NICKEL WURKS FINISH
1988 through 2007
This Specbolt full engine fastener kit will come completely labeled and contains the following fastener sets for easy installation on your YFS200.
FULL ENGINE:
- Crankcase Bolts and Drain Washer.
- Top End Kit including 6 Cylinder Head Acorn Flange Nuts paired with 6 Copper Crush Washers, Cylinder Base Nuts, Bolts for Reed Valve/Intake, Exhaust Nuts.
- Left Side Engine Cover Ignition Cover bolts.
- Right Side Engine Covers Clutch Cover and Oil Pump Cover Bolts
With a Specbolt Nickel Wurks Engine kit, you will get a Wurks Ti look for your bike.
Image for reference only, showing the type of fasteners that make up this kit. Phillips screws are upgraded to 10.9 grade modern JIS 8mm head dimpled flange bolts, designed to out-perform stock hardware.
Used by these top guys and others:
Chad Watts
Tom Morgan
Rob Selvey (RIP)
RPM Racing Team KTM
Adam Millar
AEO Powersports
Cody Webb
BRC
Team Gas Monkey Energy
AJE Motorsports
Roodz Garage
Frankie Garcia
Jay Clarks DirtbikeTV
MRE
Mojo Motosports
Dirt n Irons Rado
XC Gear
Rowland Sands
Steward Baylor
Zeal Racing
Tyler Monagan
Ron Lechien
Aaron Colton
Bill Dill (RIP) 3D Racing Yamaha
Brad Baker
Broc Shoemaker
Cooper Abbott
Destry Abbott
David Vuillemin
Devin Harriman
Jeff Emig
Ryan Hughes
The Deegans
Justin Starling
Kristopher Puffer
Lars Larsen
Marty Tripes
Dirt Bike Magazine Builds
Mickey Dunlop
Mike Brown
Ronnie Renner
Twitch
Scott Burnworth (RIP)
and more...