Package include:

4x-Wheel Spacers

Specification：

Wheel bolt pattern: 4x115mm

Vehicle bolt pattern: 4x115mm

Thread Size: M10x1.25 or 10x1.25 or 10MMx1.25

Spacer Thickness:2" or 2 inch or 51mm

Color: Silver

Number of Pieces: 4 PCS

Fitment：

For Arctic Cat:

For Arctic Cat 1000 2009-2017

For Arctic Cat 250 1999-2009

For Arctic Cat 300 1998-2016

For Arctic Cat 400 1998-2015

For Arctic Cat 450 2010-2015

For Arctic Cat 500 1998-2017

For Arctic Cat 650 2004-2011

For Arctic Cat 700 2006-2016

For Yamaha:

For Yamaha Banshee 350 1987-2006

For Yamaha Raptor 250 2008-2013

For Yamaha Raptor 350 2004-2013

For Yamaha Raptor 660R 2001-2005

For Yamaha Raptor 700R 2009-2017

For Yamaha Warrior 350 1987-2004

For Yamaha YFZ450 2004-2013

READ BEFORE ACTION

STEP-1Vehicle bolt pattern check

Confirm your vehicle bolt pattern according to the figure below.

Let's take the 5-lug wheel spacer as an example, if the length of segment as measured in the picture is 5.5”, and as there are 5 lugs, then the bolt pattern is 5x5.5". Now you should be able to determine what kind of bolt patterns you need.

STEP-2 Measurement

Measure the diameter of the center bore of the wheel spacers, make sure that it is greater than the axle diameter.

STEP-3 Check

Check the thread size, which is often ignored by customers when placing the order.
TIPS: install the supplied lug nuts or bolts on the hub only by hand (do not install the wheel at this time). It might be the wrong thread size for your vehicle when you feel resistance during the process, and please con:act the tire seller or manufacturer for further suggestions.

Installation NOTICE:

1. Clean the studs thoroughly and remove any excessive dirt, oil, grease etc.
2. Thread the supplied lug nuts to axle studs with TAPERED end facing towards the spacers.
3. Install the nuts by hand ONLY and tighten them in a crisscross pattern.
4. Do NOT use automatic screwdrivers when installing wheel spacers.
5. It is possible that your existing lug nut studs can be longer than the adapter itself, you may need to alter your existing studs if the adapters do not sit flush with the wheels. If the studs are longer than the adapter, and the wheels do not have a hollow spot in them, you may need to grind, or cut your existing lugs if you choose not to purchase shorter studs. Otherwise, the adapter bolt can、work as normal and will -r-atlv shorten the bolt's workinq life and bring danger to you.

Maintenance TIPS

• Please check all lug nuts and bolts of the adapters after the first 50 -100 miles. They may get loose after long time running. Make sure you will recheck them every 3000 - 5000 miles and screw tight.
• For any further questions, please contact the manufacturer or seller via message of website v/here you placed the order. Thank you again for purchasing your wheel spacers with us.