Audi S3 8V RS3 Exhaust Valve Electrical terminator connector ( 3 PIN )

Compatibility -

S3 8V 2013  -  Onwards  

RS3 2011 - 2016 If you’re unsure please check the electrical connector at the exhaust valves.

RS3 8V 2017 Facelift onwards will be 4 pin connectors.

Advert is for 2x 3 pin modules and 2x 3 pin blanking connectors.

The connectors allows you to terminate the wiring loom once disconnected from the exhaust module to eliminate soft fault codes appearing.

Additionally you will need the blank plugs to fit into the actual exhaust module to eliminate water and dust ingress. Not required if purchasing the full kit

Fitment -

Simply disconnect the connector the harness connector from the modules then connect the purchased component (Modules) into the wiring harness. blanking plugs into the exhaust module.

These connectors are Poke Yoke so it's impossible to fit incorrectly

If your using a aftermarket exhaust without exhaust valves fitted the full kit is not required and you will only require the modules, (See other listing)

Please check compatibility with your vehicle before purchase.