PWM Brushless Motor Control Board for 12V 36V 500W without Controller
Features: and
Motor driver board 12-36V for power input , VCC positive power supply,GND power supply is negative.
speed high and low output IC can not understand the information with the customer request
This board has many functions such as stall for protection, enable control, over-current for protection, steering control and speed control
This driver board has many advantages including low consumption, high reliability and efficiency.
Electrical wiring: three-wire brushless for motor, corresponding to MC/for
Tip: If you use a heat sink smaller than 60W and no additional heat sink, you must add a heat sink above 60W. If the driving efficiency of the heat sink is not reduced, excessive temperature will cause damage!

Specifications: Operating for 12V-36V
Operating Current: <=15A
Driver Power: <=500W
Speed 0.1V-5V
Operating Temperature:-40-85C
Humidity: 90%RH
Stall protection:Yes
Enable Control: Yes
Over-current protection: Yes
Steering control: Yes
Speed control Yes
Size: approx 63x42.5x17mm/2.48x1.67x0.67in
Power terminal Out:
VCC(positive power supply)
GND(negative
MC(motor phases for
motor phases
motor phase
Set for the control side:
GND control terminal ground
the governor end 0-5V
reversing control
for M tachometer output
enable control terminal

Package Includes: 1x 12-36V 500W Brushless Motor Controller

note: Due to the problems of lighting effects and angles, there will be certain tolerances in the product, please understand.
Please allow 0-1cm error due to the manual measurment.
Due to different motor manufacturers to make the of line order does not necessarily follow the line on the board to the need to be adjusted, please parents who pay attention! If the line wrong, does not boot properly, current, or other phenomena not open, forced to use the plate will burn!!!