GA25-370 12V 60RPM 1Pcs Small Size Metal DC Gear Motor Geared lower noise
Precautions for the use of the motor
1, before use to confirm that the motor voltage is correct, is a DC motor, but also to confirm that the power supply current is sufficient 2, can not be overloaded use, overloading reasons are mainly divided into two parts, the torque and the shaft force, the load torque can not exceed the rated torque of the motor, the shaft force can not exceed the axial and radial axial allowable force, plus the load after the motor current can not be more than the rated current, the general use of the motor must be General motor use must be equipped with a fuse to avoid overload burn motor
3、Do not store or operate in high temperature or humid environment, also do not place in corrosive gas, it will reduce the effect of the motor. 4、When assembling transmission parts such as gears and pulleys on the motor shaft, do not knock abnormally when pressing in.
5, power supply positive and negative motor terminals to be soldered, soldering iron temperature of 340C40C, heating time of 3 seconds or less do not make the plastic deformation, in the work, so that the solder point into the motor or break the end of the wire, which will make the motor function decline. 6, installation of the motor, pay attention to screws are too long, to prevent the long screws touching the motor inside the parts.
1, before use to confirm that the motor voltage is correct, is a DC motor, but also to confirm that the power supply current is sufficient 2, can not be overloaded use, overloading reasons are mainly divided into two parts, the torque and the shaft force, the load torque can not exceed the rated torque of the motor, the shaft force can not exceed the axial and radial axial allowable force, plus the load after the motor current can not be more than the rated current, the general use of the motor must be General motor use must be equipped with a fuse to avoid overload burn motor
3、Do not store or operate in high temperature or humid environment, also do not place in corrosive gas, it will reduce the effect of the motor. 4、When assembling transmission parts such as gears and pulleys on the motor shaft, do not knock abnormally when pressing in.
5, power supply positive and negative motor terminals to be soldered, soldering iron temperature of 340C40C, heating time of 3 seconds or less do not make the plastic deformation, in the work, so that the solder point into the motor or break the end of the wire, which will make the motor function decline. 6, installation of the motor, pay attention to screws are too long, to prevent the long screws touching the motor inside the parts.
