|
- Fixing the blinking (Hyper Flash) of LED in signal light bulb
- Speed Adjustable Design
- Rated Voltage: DC 12V FOR CAR USE
- Pin Length: 0.45 Inch / 1.15Cm
- Switch Current: 0.02~20A
- Pin Position: Negative pin(-) at left; Positive pin(+) at right. (Please check the original relay of yours is the same type as this product before purchase.)
- Application: Solve LED related turn signal problems such as hyper flashing
- Plug N' Play directly (check your origin relay in car, usually located in fuse box)
- Universal Part No. : CF14 JL-02 (Universal Standard)
- FLASH SPEED FOR SIGNAL/TURN LIGHT APPLICATION--
Normally when you flip your turn signal switch, the light blinks at a set, slow pace. However, if you have modified your lights to use LEDs, you'll notice that the turn signals now blink very quickly (Hyper-Flash).
This is caused by the low resistance of the LEDs due to the fact that they use less power. To correct the problem, you'll need to wire the turn signals in a parallel circuit. To do this, you'll be installing a resistor or control flasher. Another solution is the installation of Load Resistors which are wired across (in parallel with) the turn signal bulbs to simulate the load of a standard filament bulb. We also have Load Resistor available in our car bulb shopping category.
|