Designed specifically for FiTech EFI Touchscreen Controls with a 4.5" screen.

Bracket attaches to the dashboard with screws or double-sided tape... or can optionally fit between trim on your dashboard. Holder can slide in and out of bracket or the holder can be mounted without the bracket. The touchscreen controller sits on the holder and is secured with your choice of velcro or magnets.

This product was designed to connect to the underside of a classic vehicle dashboard. Please check measurements prior to ordering or if placing in a different location.

Finish: 
Powdercoated - satin black paint
Material: 22 ga. Mild Steel

Benefits:
  • Keeps your EFI control screen and wiring secure, protected and out of the way
  • Use your control screen by easily removing it from the holder.
Items Provided:
  • 2 low-profile screws
  • Felt padding to protect the base of the touchscreen control
  • Velcro and magnets to hold the touchscreen control to the holder
Dimensions: 4 5/8" wide x 3" height x 3" depth. Top Mount - 4 3/4" length x 1.5" depth
Double check for dash location fitment prior to ordering.

Returns: Unmodified products can be returned for a full refund (minus shipping) up to 30 days after purchase. $3 will be deducted if any of the original items are installed, missing, or damaged.


TDOG is not responsible for improper installation, damage done to your control screen or damage to your vehicle. Please read all instructions thoroughly before installation of your touch screen and control holder. Product may vary slightly for improvement purposes. 


Proudly made in the U.S.A. © 2019 TDOG. All Rights Reserved. The Go-EFI brand is a trademark of FiTech Fuel Injection.