V2 Lift Kit Custom Universal Frame/Chassis for Lifted Raised Off-Road Trucks or Cars 1/24 1/25

V2 Lift Kit Frame You may need to modify bed or rear section of kit to fit like you want it to. The Universal Frame allows a wheel base of up to approximately 153mm. Frame width at its widest point (middle section) is approximately 58mm. Measure you kit's wheelbase. Cut the long section of the front frame and join to rear section to make the full frame. Use the sections you just cut to reinforce the thin section of the frame. The front suspension is not adjustable but the rear axle does have some room for customization. Additional modifications to you kit may be needed to make this fit the way you want. Sanding is recommended to get to your preferred smoothness. This is based on fan art suspension. It is a custom lift kit. Warmer months are here and packages get hot during shipping. Some parts are thin and may warp during transit. The hot/cold water trick will help to straighten them out. We do not recommend you bending them without warming it up. It will snap. Assembly instructions are not available. We encourage you to use the pictures in this listing for guidance. If you are not familiar with resin, please research before purchasing. These are not for beginners. As with all resin, this will need some work like sanding smooth, cleaning flash, evening out surfaces, filling pinholes, reshaping, and/or fabricating parts. With the heat that occurs during shipping, some parts may slightly warp. Be prepared to reshape using the hot/cold water method. Parts may come attached to support tree. Resin color may vary from pictures. Color may not match all parts.