Replacement Filter For FD4625 6.7 Powerstroke Fuel Filter Element HC3Z-9N184-C

 

Product Description

Replacement Part Number:

Replacement For FD4625,FD4624,FD4647,HC3Z-9N184-B,HC3Z-9N184-C.

Feature:Meet modern diesel's engine demands for optimum fuel flow which ensures the system is free of contaminants and water.98% water separation efficiency.Effectively filter impurities.

Package includes: 2 Packs (1 Pack includes 1 x engine mounted filter and 1 x frame mounted filter,and gasket for the filter.NOT includes the HC3Z-9A317-A clip).

Recommended replacement period:The replacement of the fuel filter every 15,000 Miles.

 

Fuel Filter Compatible with:

For 2017-2025 F-250 Super Duty Powerstroke 6.7L V8 

For 2017-2025 F-350 Super Duty Powerstroke 6.7L V8 

For 2017-2025 F-450 Super Duty Powerstroke 6.7L V8 

For 2017-2025 F-550 Super Duty Powerstroke 6.7L V8 

For 2017-2025 F-600 Super Duty Powerstroke 6.7L V8 

For 2017-2025 F-650 Super Duty Powerstroke 6.7L V8 

For 2017-2025 F-750 Super Duty Powerstroke 6.7L V8

 

Changing frame rail filter:

Place the drain pan under the water in fuel separator filter housing under the cab between the frame rails,drain fuel.Remove 5 fuel filter housing mounting bolts using the 8mm socket,replace filter element and housing gasket.Reinstall filter housing and plug in water in fuel sensor connector.

 

Changing engine filter:

This fuel filter is located in the drivers side of the engine bay(with 3 fuel lines going into it).Remove all 3 fuel lines going to filter by sliding plastic clips over and pulling lines away from the filter one at a time.Loosen the filter from its housing by loosening it a 1/4 turn.Install new fuel filter and tighten.Cycle the key to the ON position and leave it for 30 seconds.Turn the key to the OFF position, and the back on-repeat this cycle 3 times.

 

Ensure proper installation to prevent leaks!

Step 1: Remove Old Filter

Hold the filter, slide it ALL THE WAY to the right, then pull it up.

Step 2: Seal Installation Guide 

Remove the old seal, clean housing, install new seal, seat evenly and press firmly into place.

Step 3: Installing New Filter

Align with the directional arrow, insert vertically on the RIGHT side, then slide it FULLY to the LEFT until secure.