✅ Easy Installation Guide

For best results: follow this method for perfect placement and a smooth finish.

Dry installs are risky — once it sticks, it’s stuck! The wet method gives you room to adjust.

🚗 Quick Steps

1. Clean the Area
Wash with dish soap + water (no wax!) and dry completely.

2. Make Your Spray
In a bottle: water + a few drops of dish soap + splash of rubbing alcohol. Shake it up!

3. Spray the Truck
Soak the area — especially the inset letters. It should be visibly wet.

4. Place the Letters
Peel and stick one letter at a time.
Avoid touching the sticky side.
It will slide — that’s what you want! Adjust and move to the next.

5. Press Gently
Once all are placed, go back to the first and lightly press out water with your fingers.
If anything shifts, just slide it back.

☀️ Let It Set

If sunny:
Let it sit 20–40 min outside to dry.
Press everything once more after.

If not sunny:
Use low heat (blow dryer or heat gun) in short bursts.
Warm, press, repeat until dry and stuck.

🎉 All Done!

Enjoy your perfectly placed decals — clean, smooth, and ready to go!