Tips for use
1. The gap can be adjusted in 0 ~ 3mm, (under the pressure plate with a washer) according to their own need to commonly used workpiece thickness to determine, for example, commonly used is 0.1-1.0 can be adjusted to the gap of 1.0 where 1.0 below the need for further adjustment, such as commonly used is between 1.0-2.0, adjusted to 2.0 where 1.0 to 2.0 between the need for no further trouble, and so on. Facilitate the workpiece in the gap under the pressure plate can move freely. The advantage of doing so is that there is no need to take out a pressure plate for each folded edge, saving labor and time. Especially suitable for mass production.
2. Angle can be controlled at 60-180 ° (with angle adjustment dowel adjustment), for example, to fold into 90 ° to be adjusted to 88 ° or so, because the workpiece has a molding rebound, please work in practice according to the need and the possibility of determining the angle of position.
3. Rich molding capacity. Folding “hex” “mouth” “L” “B” “U” and other types, and can be Folding other bending machine can not be folded less than 90 ° of the complex shape, such as to fold the four sides upward, you can first fold 2 small side, after a slightly higher than the height of the small side of the plate bottom, and then fold the other 2 sides, (this time, we have to take out the pressure plate, adjust the height) can be satisfied with the results. Please use it in practice, to give full play to its functional advantages!