Feature:

1. This sensor meter is lightweight, small and easy to install
2. The internal impeller has stainless steel shaft which is quite wear-resistant
3. Seal uses mechanical structure that stressed from up and down directions and will not leak
4. The sensor has high quality Hall effect and is encapsulated with glue, preventing from water entering
5. It is a great sensor of high precision, long service life and stable performance

Specification:

Description:

Water sensor is mainly composed of plastic valve, water rotor subassembly and hall sensor.It is mounted on water heater inlet and used to meter water . When water goes through rotor subassembly, magnetic rotor rotates and rotating speed changes with the . Hall sensor outputs corresponding pulse signal as feedback to controller and controller judges water amount and adjusts .

Features:

• This sensor meter is lightweight, small and easy to install.
• The internal impeller has stainless steel shaft which is quite wear-resistant.
• Seal uses mechanical structure that stressed from up and down directions and will not leak.
• The sensor has high quality Hall effect and is encapsulated with glue, preventing from water entering.
• It is a great sensor of high precision, long service life and stable performance.

Specifications:

Working Range: 1~30L/min
Water Pressure: ≤1.75MPa

Pipe Thread: G1/2 (DN15)
Thread Outer Diameter: Approx. 2cm

Output Waveform: Square wave

Size: 6.1*3.4cm/2.4*1.3in

Wiring:

Red: IN+

Yellow: OUT (signal output)

Black: GND-

Note:
1, Forbidden to severe impact and chemical erosion.
2, Forbidden to throw or collision.
3, Water detection should be same as the on sensor.
4, Water temperature should not be more than 120℃.

Package Includes:

1 x Sensor