eBay

*** IMPORTANT - Custom Ordering ***

Ebay has a hard cap for the amount of variations I can have active. So some combinations are not shown and need to be requested. For the following situations below, I have additional steps to order:

LEFT HAND OPTION - Left hand grips need to be requested

OPTION NOT LISTED - Certain combinations of grip angle, texture and color are not active and need to be requested

Carbon One & Carbon One X Models - These models need to be requested. The fitment from Bowtech requires a slight adjustment for these carbon bows.

~~~ Steps to Order for options not listed ~~~

During checkout, there is a section "Add note for seller". You can request any options above such as left hand or grip angle / color option not active.

After ordering, please message me with the same note during checkout. This is to ensure I get the order correct if ebay doesn't pass me the information.

--- Bow Model Fitment ---

These grips will only fit the bow models PRIOR to the GripLock system. If you have the adjustable GripLock system, please see my other listing. Again these are only for the original Non-Adjustable clutch grip. It will fit these models below:

Reckoning, Reckoning 38
Realm, Realm X, Realm SR6, Realm SS
Revolt, Revolt X, Revolt XL, Revolt X80
Solution, Solution SD, Solution SS, Solution LS
CP28, CP30
Specialist II
Eva Shockey Gen 2
SR350
SS34
SX80

*** Wide Version - This will make the face of the grip about 1/8" wider. Please see the picture showing the difference.

--- What's Included ---

1) Grip - 1 grip in your choice of color and grip angle

2) Removal Tool - black only

Decided to make grips for the Bowtech models utilizing the clutch grip system. Angle options to help those who wanted to get a more natural wrist position which would translate to a steadier hold.

--- Color Options ---

Colors available are shown in the 2nd picture showing the color options. If you wanted a combination that is not active just message me.

--- Installation & Removal ---

These use the clip system Bowtech has integrated into the riser. These grips will snap into place using the same modular system. These will lock in pretty tight which I will include a removal tool. The removal tool you will slide between the small gap between the grip edge and the riser edge from the side.

You will slide it in on the index finger side of the grip. Basically the only way I found to easily remove these grips is to pop off the bottom 2 to 3 clips at once. Once it is slid in the gap you will bend it back away from the grip with slight down pressure, and the 3 clips will partially pop out. You may need to use your finger at the bottom corner to help the grip not slip back in the grooves when releasing the removal tool. Use your finger on the top curve to release the clip and gently pry it off.

I made the grip gap to fit a standard gift card. So if the removal tool breaks you can use a old gift card as a replacement tool. These will only come in black no matter the grip color option chosen.