eBay

*** IMPORTANT - Custom Ordering ***

Ebay has a hard cap for the amount of variations I can have active. So some combinations are not shown and need to be requested. For the following situations below, I have additional steps to order:

LEFT HAND OPTION - Left hand grips need to be requested

OPTION NOT LISTED - Certain combinations of grip angle, texture and color are not active and need to be requested

~~~ Steps to Order for options not listed ~~~

During checkout, there is a section "Add note for seller". You can request any options above such as left hand or grip angle / color option not active.

After ordering, please message me with the same note during checkout. This is to ensure I get the order correct if ebay doesn't pass me the information.

--- Bow Model Fitment ---

This listing will only fit Hoyt hunting bows up to 2021 and older. I have a separate listing for the newer model bows. Please know the model of your bow as these will fit the original Ventum but not the Ventum Pro released in 2022. Some of the models it will fit are:

Torrex
Defiant
Spyder
Charger
Matrix
Rampage
Nitrum
Katera
Element
Faktor

This is not a complete list. If you are unsure just send me a message with your bow model. If you don't know, send me a picture of your bow from the side view showing your current grip. The exception to the above rule of 2021 and older also includes the Torrex models produced in 2022.

--- What's Included ---

1) Grip - 1 grip in your choice of color and grip angle

Decided to make grips for the Hoyt hunting models. The grip face is flatter than the stock hoyt grips. I also brought over angle options like we have on the target models to help those who wanted to get a more natural wrist position which would translate to a steadier hold.

--- Color Options ---

Colors available are shown in the 2nd picture showing the color options. If you wanted a combination that is not active just message me.

--- Installation ---

The grip will come pre-installed with the duct tape on the inner side. I have a picture showing how it is installed. You may also use electrical tape if needed. I put it on the inner side of the grip so the tape doesn't get stuck to the riser's finish. This gives it a extra friction for fitment.

The grip is made to friction fit over the riser. Before installing remove all leftover sticky residue on the riser. You may opt to leave the sticky residue on the FACE of the grip. But remove any on the sides of riser.