This tri-powered factory replacement linkage set for Rochester carbs includes ball bearing joints and new carb throttle body shaft. This linkage kit is for carbs with a small base, 1-7/16 " butterflies. This throttle rod kit is designed to function as a progressive linkage with the center being the primary. It could be locked to work all 3 carbs at the same time if desired but would require correct internal carb components to avoid flooding out the engine during acceleration. Does not work with after market manifolds.
- Tri-powered factory replacement linkage set
- Ball bearing joints
- Progressive linkage with the center being the primary
- For Rochester carbs with a small base, 1-7/16 " butterflies
- Includes ball bearing joints and new carb throttle body shaft
- Designed to replace the vacuum linkage on factory GM Tri Power setups such as '58-'61 Chevys and Pontiacs
- Includes a new throttle shaft for the center (primary) carb
- Linkage connects to the passenger side of the engine
- Does not work with after market manifolds
Great part
Summary: The linkage works great and looks very good too
Yes, I recommend this product.
I would buy this part again if it fit.
Summary: I ordered this kit by the part number. I chose the wrong kit for my application. No fault of the part.
Yes, I recommend this product.
yes
Summary: Had to order new one as the one I planned on using was taken out of my shop.
Yes, I recommend this product.
Sure I would buy this again.
Summary: Takes some automotive repair knowledge but with some digging online found sound help with install.
Yes, I recommend this product.
great product
Summary: the linkage works great on our 302 GMC 3 carb setup with some modifications.
Yes, I recommend this product.
