Description

 

YPS-0550 UPSDZ Lithium Battery Capacity Tester Meter 50A Cell Charge Discharge Aging Tester Monitor

Features:
- 50A fast charge and discharge
- Quick to monitor the capacity of 5-500Ah cells
- Automatically complete the charging-discharging-charging process
- Suitable for lithium battery manufacturers of motor scooters and RVs, lithium battery maintenance and distribution of new energy vehicles, scientific research and testing institutions

Specifications:
- Working mode: automatic mode, cell charging mode, and cell discharging mode
- Detection channel: for one cell, 1.6-5V 2-1000Ah
- Charging cut-off voltage: 1-5V settable
- Charging current: 0.5-50A settable
- Discharge cut-off voltage: 1.6-5V adjustable
- Discharge current: 0.5-50A adjustable
- Charging mode: constant current and constant voltage
- Discharge Mode: Constant Current Discharge (MOSFET)
- Display parameters: capacity, voltage, current, temperature and curve
- Voltage Accuracy: 0.1% (calibrable)
- Current Accuracy: 0.2% (calibratable)
- Capacity error: discharge ±1.5%, charge ±2%
- Heat dissipation: temperature-controlled fan (maximum noise is about 60dB)
- Protection function: reverse polarity protection and high temperature protection
- Equipment power supply: AC220V 50HZ±10%, 110V can be customized
- Product size: 162 x 315 x 200mm/6.4 x 12.4 x 7.9" (WxDxH)
- Net weight: 2.7KG/6LB

Package Included:
- 1 x Battery Capacity Tester
- 1 x Pair of Alligator Clips

Note:
- Please note that its interface is displayed in Chinese.
- The voltage of cells (not included) to be tested should be lower than 5V.

 

① Switch: If the power is suddenly cut off during tests, the test data will not be saved.
② Screen: display the parameters of charging and discharging and the discharging curve.
③ Setting Knob: rotate the knob to adjust working modes and press it to adjust parameters.
④ Start/Stop Button: Before any operation, tests must be stopped.
⑤ Connect the positive pole of a cell (pin definition: pins 1-2-3 are connected in parallel with excessive current, and pin 4 is for thin wire for voltage detection)
⑥ Connect to the negative pole of the cell (pin definition: pins 1-2-3 are connected in parallel for excessive current, and pin 4 is for thin wires for voltage detection)

How to use?
1. First, set the charging and discharging parameters of the machine according to the charging or discharging parameters provided by your battery manufacturer. For batteries without clearly marked charging or discharging parameters, the following data can be referred to:


2. Turn it on without connecting any battery. Press Setting knob once to enter the parameter setting page. After setting the charging and discharging parameters, save the data and exit (the parameters can be selected when pressing Setting; the parameters can be adjusted when rotating Setting).
3. Three working modes can be selected on the main page (rotate the Setting knob left and right):① Cell charge mode: only charge a cell. ② Cell discharge mode: only discharge a cell. ③ Cycle mode: automatic charging of the battery - discharge - charged. End page: After charging or discharging, its screen will display information such as capacity.
4. During tests, if you need to disconnect the cell or reset the parameters, you must press the Stop button first.
5. After the test, it will display the test result.
6. The voltage drops rapidly during the discharge test, which indicates that the fixture is in poor contact with the cell or the discharge current is too large.
7. The voltage rises rapidly during the charging test, which indicates that the fixture is in poor contact with the cell or the charging current is too large.
8. If the cell heats up seriously during the test, it means that the charging and discharging current is too large.