| Material | Standard Resin |
| Surface Hardness (Shore D) | 80-85 |
| body contraction (%) | 7-9 |
| Tensile Strength (MPa) | 20-40 |
| Elongation (%) | 5-15 |
| Bending Strength (Mpa) | 25-45 |
| Flexural Modulus (Mpa) | 650-900 |
| Lower exposure time (s) | paint screening machine 20-80; |
| Black and white machine 10-60 | |
| Lowest layer | 3-5 |
| Normal layer exposure time (s) | paint screening machine 4-15; |
| Black and white machine 1.5-4 | |
| Stroke distance (mm) | 6-10 |
| Lifting speed (mm/min) | 60-90 |
| Lifting speed (mm/min) | 120-180 |
| colour | Black/White/Dark Gray/Skin/Clear |
| features | 1. Standard photosensitive resin, suitable for beginners and model hand printing, 2. Easy to form, good precision, low odor, high cost performance |
Precautions:
1. Shake well before use. It is recommended to stand upside down three times. It is forbidden to use resin in places exposed to sunlight;
2. Do not take it orally, keep it away from children, wear gloves before use, avoid direct contact with the skin, and keep the room ventilated; do not enter the eyes, in case of accidental contact, rinse with plenty of water as soon as possible.
3. The printed resin model needs to be cleaned with high-concentration alcohol (recommended above 95% concentration, the higher the better) for about 30s; after cleaning, wait for the alcohol to dry and then perform secondary curing, so that the best performance can be obtained;
4. Do not pour the used resin in the trough back into the unused resin, and do not leave the resin in the trough for a long time without use. The contamination of the resin affects the printing effect;
5. Store in the dark at room temperature. The ultraviolet rays in the sun will cure the photosensitive resin; it is recommended to store it at an ambient temperature of 15-35 °C. The lower the temperature in winter, the higher the resin viscosity;
6. Sealed storage to avoid dust or moisture, which will affect the print quality
1. Shake well before use. It is recommended to stand upside down three times. It is forbidden to use resin in places exposed to sunlight;
2. Do not take it orally, keep it away from children, wear gloves before use, avoid direct contact with the skin, and keep the room ventilated; do not enter the eyes, in case of accidental contact, rinse with plenty of water as soon as possible.
3. The printed resin model needs to be cleaned with high-concentration alcohol (recommended above 95% concentration, the higher the better) for about 30s; after cleaning, wait for the alcohol to dry and then perform secondary curing, so that the best performance can be obtained;
4. Do not pour the used resin in the trough back into the unused resin, and do not leave the resin in the trough for a long time without use. The contamination of the resin affects the printing effect;
5. Store in the dark at room temperature. The ultraviolet rays in the sun will cure the photosensitive resin; it is recommended to store it at an ambient temperature of 15-35 °C. The lower the temperature in winter, the higher the resin viscosity;
6. Sealed storage to avoid dust or moisture, which will affect the print quality
