Product Description

1

2-4" Lift Front Upper Control Arms with Ball Joint For 2004-2020 F150 2WD 4WD

FLYCLE upper control arms(UCA) are a better replacement for OEM upper arms.If your truck have 2 inch or more lift（installed the front leveling kits),the factory upper control arm would limit the suspension which will affect driving performance,our upper control arms will slove these problems.Upgrade your turck front upper control arms,they will give your truck an aggressive look.

6

Fitment

2004-2020 Ford F150
Will not fit 2010-2014 SVT Raptors or 2017-2018 Raptor models.

 

2

3

2

High quality greasable ball joints with a protective cap to keep out dirt and debris.

Fully TIG welding and lagerer diamter pipe improve and increase the strength of the suspension.

Replacement the factory control arms,it will give your truck an aggressive look.

 
6

Installation Steps:

 

  1. Jack up the car, get tire off. Take inner wheel off.Bend back a little to get enough room.
  2. Loosen the long bolt coming through 2 sides. Remove ABS line.
  3. Pull out cotter pin, loosen castle nut.
  4. Ball joint out by hammer.
  5. Remove sway bar end line from the spindle.
  6. Remove long bolt, wiggle old arm out.
  7. Install back new front upper control arm.

 

 

DataCaciques
1. Do not use impact wrench.Please use hand wrench. Recommended to use threadlocker.

2. Returns are only accepted if unused and not  installed.(Returns ARE NOT ACCEPTED IF SPACERS-ADAPTERS HAVE BEEN INSTALLED TO YOUR VEHICLE)

-- Vehicle fitment compatibility is only a guide, please ensure that these are the correct ones for your vehicle.