eBay

*** IMPORTANT - Custom Ordering ***

Ebay has a hard cap for the amount of variations I can have active. So some combinations are not shown and need to be requested. For the following situations below, I have additional steps to order:

OPTION NOT LISTED - Certain combinations of style and color are not active. Or if you wanted a mix match of selections. Both can be requested.

~~~ Steps to Order for options not listed ~~~

During checkout, there is a section "Add note for seller". You can request any options above such as style / color option not active.

After ordering, please message me with the same note during checkout. This is to ensure I get the order correct if ebay doesn't pass me the information.

--- Fitment Info ---

These knobs will fit Truball thumb and hinge releases. Installation instructions in the next section for hinge releases.

For thumb releases, Truball has now included a newer style adjustment thumb post, I want to emphasize that these knobs will NOT fit the newer style post. Please see the last picture of what that newer post looks like. You will be able to use these using the direct fit or the older style teardrop extension. So if you do have the newer style post you won't be able to use these with it.

There are 3 different sets to choose from that combine size and Knurl options. The larger 3/4" knob has a offset hole to allow you to set the position to your liking. The smaller 5/8" knob has no offset.

1) Diamond Knurl in 5/8" and 3/4"

2) Spiral Knurl in 5/8" and 3/4"

3) Gripper in 5/8" and 3/4"

* NOTE: You can request a custom combination of size and knurl pattern to make your own set. Just message me ahead of time.

--- What's Included ---

1) (Set of 2) Thumb Pegs

2) One set of 6-32 socket head bolt and hex nut

* NOTE: Release in picture is NOT included. Only shown as an example for fitment

--- Color Options ---

Colors available are shown in the 2nd picture showing the color options. The top 4 matte colors have a more gritty feel and only available for thumb pegs.

--- Installation (hinge models) ---

For hinge releases you would install it differently. The hex nut is not needed. Instead you would insert the socket head bolt in the hex nut recessed hole side. The hinge body will act as the hex nut.

To remove the hex nut, thread the socket head bolt in the hex nut a few theads and use the bolt to wiggle the hex nut out.