

Fit Vehicles:
2003-2007 Honda Accord 2.4L
Features:
Supplied With a Factory-Fitted Connector for Easy Installation
Precision manufactured with a sensing element incorporating premier technical ceramics
Where are my oxygen sensors located?

Diagnostic Trouble Codes (DTC)
When oxygen sensor failure occurs, a DTC is recorded in the Engine Control Unit (ECU) and a Malfunction Indicator Lamp (MIL) is illuminated on the dash, alerting the driver the vehicle has a problem.
How to replace an oxygen sensor?
1- Disconnect the battery.
2- Locate the sensor connector by following its wires. Disconnect it.?
3- Remove the sensor cable from its clips all along its way to the sensor.
4- A specific 22mm socket with side cut out exists (see below). You can use a spanner instead. Hold it in one hand and give it a firm hit with the other hand. It will then unscrew very easily.
5- Remove the sensor and fit the new one.
6- Re-route the cable carefully and meticulously and fix it at every clip. Reconnect the connector.
7- Reconnect the battery and wait 5 minutes before starting the engine.


Please take a video clip of the voltmeter and contact us if our sensor:
Goes above range between 0.1 and 0.9 volt
Remains below 0.5 volts
Stays fixed at a particular voltage
You're free to choose replacement or refund if our sensor fails to work, in this case.
Please use the link "Ask the Seller Question" or send "eBay message" in you "My eBay" to contact us if you have problems, special requests or suggestions, we are very glad to help you anytime. we will reply you within 24 hour.