DDT Endcaps for Minelab Excalibur.

Type of endcaps: 

1. PG7 cable enter for headphones (kit includes connector for mother board, black protective cover, sealing ring);

2. M12 8pin CTX-type for headphones (kit includes installed connector for motherboard, black protective cover, sealing ring)

3. M12 8pin CTX-type for headphones + male 8pin connector (kit includes installed connector for motherboard, black protective cover, sealing ring, male connector M12 8pin)

4. PG7-PG7 for battery and coil (kit includes two flexible enters PG7, sealing ring, black protective cover)

5. PG7-M12 for battery and coil (kit includes installed cable for battery, installed female 4pin connector for coil (white - GND, yellow - RxA, black - TxA, red - TxB), male 4pin connector for coil, sealing ring, black protective cover).

6. Endcap for battery (kit includes installed connector for battery pack, sealing ring, black protective cover).

Notice for installation:

For endcap installation need to use silicone grease, which need to put on rubber ring. After endcap installation it is necessary to install black protective cover from kit.