BOXI
  • Pretty Auto is one of the fast-growing automotive aftermarket parts online providers in America. With more than 25 years experience in the industry, All parts will meet or exceed OE specifications, which will be an ideal choice to replace your broken parts.
  • Placement of lift supports,struts,dampers could be front or rear hood, trunk, tailgate,liftgate, trunk lid, hatch,rear window glass,tailgate assit,storage box and so on.
  • Also supply a variety of mortor parts, such as ABS sensor, door handle, cooling fan, ERG value, water pump, window regular, blower assembly, fuel pump, ignition coil, belt tensioner assembly, valve cover, thermostat assembly, TPMS sensor, VTT Valve, timing chain kit, hub bearing assembly etc.....

Specification:

Extended Length [in] 23.93
Compressed Length [in] 14.18
Fits the following Chevy Blaz-er Years:
1995-2003 | Base Sport Utility | With Liftgate (exc Drop Gate type)
1995-2003 | LS Sport Utility | With Liftgate (exc Drop Gate type)
1995-2003 | LT Sport Utility | With Liftgate (exc Drop Gate type)
1999-2003 | Trailblaz-er Sport Utility | With Liftgate (exc Drop Gate type)
Fits the following G-M-C Jimm-y Years:
1995-2000 | Base Sport Utility | With Liftgate (exc Drop Gate type)
1998-2000 | Envoy Sport Utility | With Liftgate (exc Drop Gate type)
1995-2000 | SL Sport Utility | With Liftgate (exc Drop Gate type)
1995-2000 | SLE Sport Utility | With Liftgate (exc Drop Gate type)
1995-1998 | SLS Sport Utility | With Liftgate (exc Drop Gate type)
1995-2000 | SLT Sport Utility | With Liftgate (exc Drop Gate type)
Fits the following Olds-mobile Brava-da Years:
1996-2000 | Base Sport Utility | With Liftgate (exc Drop Gate type)
 

Easy to install:

 
  • Find Someone or Props hold the hatch, hood or rear window open while replacing the lift support, so that they can raise or lower it as needed.
  • Before removing the old lift supports, inspect the end connections and compare them the the units on your vehicle to make sure that they are the same as well as the extended length.
  • Remove the lift support struts retaining clips by using a flat head screwdriver.
  • Slowly turn the screw driver and it will lift up the retaining clips. Then pull the support away from the vehicle and it will release.
  • To install the new supports do the same procedure in the reverse. DO NOT jam the new support end over the ball socket without lifting the retaining clips slightly damage may occur.
  • Push the strut onto the ball joint. Place the strut over the ball joint and use your tool to apply pressure until it pops into place.
  • Move the Props to see whether the supports work good.
    		•

    Attention:


    Package Includes:
    1 × Lift Supports
    <!doctype html>
    无标题文档