eBay

BOXI

Pretty Auto is one of the fast-growing automotive aftermarket parts online providers in America. With more than 25 years experience in the industry, All parts will meet or exceed OE specifications, which will be an ideal choice to replace your broken parts.
Placement of lift supports,struts,dampers could be front or rear hood, trunk, tailgate,liftgate, trunk lid, hatch,rear window glass,tailgate assit,storage box and so on.
Also supply a variety of mortor parts, such as ABS sensor, door handle, cooling fan, ERG value, water pump, window regular, blower assembly, fuel pump, ignition coil, belt tensioner assembly, valve cover, thermostat assembly, TPMS sensor, VTT Valve, timing chain kit, hub bearing assembly etc.....

Specification:

Product information:
Placement on Vehicle: Front Hood Left & Right
Extended Length[in]:17.84"
Compressed Length[in]:11.34"
Reference Number: 2088800029 SG303001 6276

Fitment:

Only Fits

1997-2003 Mercedes-Benz CLK320 Base Convertible 2-Door Hood

1997-2003 Mercedes-Benz CLK320 Base Coupe 2-Door Hood

1999-2003 Mercedes-Benz CLK430 Base Convertible 2-Door Hood

1999-2003 Mercedes-Benz CLK430 Base Coupe 2-Door Hood

2001-2002 Mercedes-Benz CLK55 AMG Base Convertible 2-Door Hood

2001-2002 Mercedes-Benz CLK55 AMG Base Coupe 2-Door Hood

Easy to install:

Find Someone or Props hold the hatch, hood or rear window open while replacing the lift support, so that they can raise or lower it as needed.

Before removing the old lift supports, inspect the end connections and compare them the the units on your vehicle to make sure that they are the same as well as the extended length.

Remove the lift support struts retaining clips by using a flat head screwdriver.

Slowly turn the screw driver and it will lift up the retaining clips. Then pull the support away from the vehicle and it will release.

To install the new supports do the same procedure in the reverse. DO NOT jam the new support end over the ball socket without lifting the retaining clips slightly damage may occur.

Push the strut onto the ball joint. Place the strut over the ball joint and use your tool to apply pressure until it pops into place.

Move the Props to see whether the supports work good.

Attention:

Please check the descriptions and compatibility chart to ensure that the replacement fits your auto before your purchasing.
The lift supports with strong force can't be pressed by hand. Please use appropriate shop manual for your vehicle to obtain specific service instruction. If you do not have an installation manual or not enough skill to install this part, it is recommended to seek the help from a qualified machanic.

Package Includes:
2 × Lift Supports

无标题文档