Skeleton Horde

The undead is on the move, this horde will create panic and chaos everywhere it goes. These Skeletons are printed in resin and are modular, with separate parts so require some assembly. The full set comprises two command units, 8 sword skeletons, 8 polearm skeletons (4 scythes, 4 spears), and 4 axes. It also comes with 20 round shields (4 of each type). You can specify which shields you would like as seen on the commanders image by messaging us. They are ideal for any tabletop wargaming and RPGs, such as Oathmark, Warsurge, Pathfinder and Dungeons and Dragons. They are 28mm scale a choice of bases. These are supplied separately and require attaching to the model. If you have any special requirements (such as a different size, or a mirrored version), please don't hesitate to contact us, and we will see what we can do. We print each miniature to order, please allow up to 14 days for dispatch, we clean, cure and prepare our minis by hand whilst we endeavour to make sure each is as perfect as can be. However, little evidence of the supports used during printing might still be visible. Models may require some tidying up as you would with any miniature, and can be done so carefully with a sharp craft knife or fine sandpaper. Please take care not to breathe in any resin dust, if after cleaning up the model, it is slightly sticky then place it in direct sunlight until solid. Make sure you wash your hands afterwards as uncured resin can be an irritant. Some of the images used in these listings are 3D renders and are shown as a presentation of the final print. Though the resin is pretty strong and resilient, it is not as strong as plastic miniatures. They may break from excessive force such as being dropped. Please be aware that resin constantly cures when in contact with UV (such as sunlight), this can cause the miniature to become brittle over time, to protect it, you should prime, paint or coat in a UV blocking lacquer or varnish. We are a licensed reseller for Monstrous Encounters. You can find out more about their models via their Patreon: https://www.patreon.com/monstrousencounters/posts, or store on MyMiniFactory: https://www.myminifactory.com/users/Monstrous%20Encounters. If you would like a Monstrous Encounters model printed and we have not listed it, please contact us to see what we can arrange.