Ten Second Color (TSC) and Active Elements (AE) are penetrating dyes to color concrete and other cementitious surfaces.  When properly applied, they create beautifully mottled effects similar to acid stain in a matter of seconds without the wait time required by acid, saving you time and money.  TSC and AE are translucent dyes, and colors can be combined into countless variations and hues, or layered for unique effects. 

You Must Add Acetone

Simply fill the remainder of the container with acetone (32 ounces) and go!  For interior and exterior use.


Coverage– One 32 Ounce Container of Dye covers an average of 100-150 sq ft. Coverage variations depend on concrete surface porosity and amount of material applied.

Application Instructions:

Step 1: Concrete must be very clean, dry and porous. (Water must readily soak in and concrete should feel similar to 120 grit sandpaper.)

Step 2: Apply Dye with a cone tip pump sprayer that is compatible with acetone. TSC Dye can also be applied with a brush, roller or HVLP spray equipment. 

Step 3: Allow to dry completely and apply sealer.



Speed Color™ Dye samples shown are representative of Speed Color applied to standard, gray concrete using the directions provided on the Technical Data Sheet. Results may vary depending on the condition, age and makeup of the concrete, and/or the application methods used. Always test prior to use.