​ 104068-02

The 104068-02 is an OEM HSI Ignition Control Assembly Circuit Board made for DESA International branded portable heaters such as All-Pro, Master, Reddy, Remington, and Universal.


The 104068-02 Ignition Control Assembly we are offering is the original equipment replacement part for the specific heaters listed and should be used according to the instructions. 

Note:
Electrical parts that have been opened are not returnable or refundable.
No returns will be allowed on Electrical parts that have been installed.

Compatible All-Pro Models:

Compatible Master Models:

  • B70D, B70DT, B70ET
  • B100B, B100BT
  • B115, B115DT
  • M125T, M125AT
  • B150J, B150JT
  • B155T, B155CT, B155DT
  • B165A, B165CT, B165DT
  • M170T, M170AT
  • M200T, M200AT
  • B165AT
  • B200AT, B200BT

Compatible Reddy Heater Models:

  • R35D, R35E
  • R40, R40T
  • R50BT, R55A, R55B, R55BT
  • R60, R60A, RM60
  • R70DT, R70ET, R70D
  • R110C, R110B, R110BT
  • R115, R115C, R115DT, R115T, RM115
  • RH125T, RH125AT, RHD125T, RL125T, RE125T
  • R155B, R155C, R155D, RM155
  • R165A, R165AT, R165CT, R165DT
  • RH170T, RH170AT, RHD170T, RE170T, RL170T
  • R200A, R200BT, RM200AT, RE200T, RHD200T

Compatible Remington Models:

  • REM35B, REM35C
  • REM40
  • REM50C
  • REM55A, REM55B
  • REM60
  • REM110B, REM110BT
  • REM115, REM115T
  • REM150E, REM155B
  • REM200AT

Compatible Universal Models:

  • UK55
  • UK70T
  • UK115T
  • UK165T

Warning:

Never service a heater while it is plugged in, operating or still hot. Severe burns and electrical shock can occur.

Note: Correct pump pressure must be calibrated after installation.

  • This can be done using a low pressure gauge such as the DESA HA1180 gage or an equivalent.
  • This can also be done by turning your adjusting screw clockwise until the nose cone of the heater is glowing orange except for the last inch of you nose cone.
  • This will give you the optimum heat from your unit as well as the least amount of fumes. If fumes burn your eyes discontinue use and consult a service technician.
  • When removing replacement Rotor from the package and installing into the heater, do not strike or drop the rotor or damage may occur.
  • Handle rotor by the body only.
  • No warranty will be given for parts damaged during installation.
  • If part is broken upon receipt a picture will need to be taken of the part in the unopened package before any parts exchange can occur.
  • For any addition information please contact our office by email through our eBay store and one of our customer service agents will respond to your question in a timely manor.