NO FIGURES INCLUDED AND NO LARGE DECK GUN INCLUDED!!!!!
Barge without sail 320mm deep x 370mm wide x 310mm height
With sail 360mm high and 457mm wide
This sale is NOT for the whole Khetanna and is for just the deck part seen in the photos. It has been printed with the intention of displaying on a shelf so you can hide the far side.
This is a limited run sale item that I will probably only sell for a few weeks as it is the only thing I have licensed from the designer.
This is at a reduced price, due to imperfections and some broken parts that need glued. It requires some glueing to give it strength and hold everything together. Superglue should work well.
A few notes: the spidery greeble has one leg missing. The sail is actually the wrong way round so is not designed to attach to the mast at the point I have shown it here, but this is how I would attach it. It may be a bit fiddly glueing that mast in place, but with a little patience it can be done. I ended up balancing my own by wedging it between the top of the shelf. There are a few small broken parts here and there, which I have glued and I have cut (in software) and reduced some bits like the mast so it fits a shelf better. If you are looking for perfection this isn't it as it was a challenge to print and build, but it should look good when displayed and it's certainly a lot cheaper than the Haslab! There's a small warped part behind the middle side part, but you won't see this with that in place. As I say, there are other small bits, like rails that need glued. The rail may need some patience to glue as I didn't manage to get that glued. Maybe held together longer will sort it. Also the hatch doors are glued shut as the latches broke when trying to put them in place.
This is made from PLA material.
Some parts are best glued. Superglue works well.
I offer combined postage for 3D prints. If you have any issues getting combined postage please contact me.
Please note:
- Files designed by Layered Creations.
- Figures for illustration purposes only and are not included.
- I do not currently offer a painting service.
- Please message me if you are interested in other LandspeederLuke/Charveys3D designs or different sizes and can't see them here.
Dispatch Times
I advertise dispatch as 10 working days just in case I get an influx of prints, but this is usually quicker.
Pricing and Quality
I'm always striving to make my prints as high quality as I can. This means my prints may take longer than other sellers because of increased layers for detail and ironing for smoother flat surfaces, which increases my print times and costs. I often reject prints if I'm not happy with them, which again raises my costs. When looking at the cost of a print please bear in mind that I need to pay a monthly license to the designer, there is the cost of the plastic for the print, the cost of buying, upgrading and maintaining expensive 3D printers, the cost of electricity and cost for my own time, which may include a lot of troubleshooting, ongoing training to improve print quality, failed prints, removing supports etc. Some prints can take several days to print so please bear in mind that the cost/time of making one 3D print is not comparable with the cost of a Hasbro diorama, which are mass produced. All of my prints are calculated using the exact same formula, based on the amount of PLA used and the amount of hours to print.