This Oxygen O2 Sensor is a new, aftermarket replacement part that has the following specifications:
Direct Fit
Correct Connector No cutting or splicing
4 wire configuration.
Manufacturer Part Number:
392102C210, 392102G200
Reading the Oxygen Sensor’s Signals
Use a 10-megaohm digital voltmeter. Hook up the voltmeter's red probe to the sensor's signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierces the wire.)
Start the engine and check the sensor’s voltage signals on your voltmeter. The sensor voltage should cycle or fluctuate within the 100 mV-900 mV (0.10 to 0.90V) range approximately. This means the sensor is operating properly.
Please take a video clip of the voltmeter and contact us if our sensor:
Goes above range between 0.1 and 0.9 volt
Remains below 0.5 volts
Stays fixed at a particular voltage
you’re free to choose replacement or refund if our sensor fails to work.
Vehicle Application:
For
For 2011-2014 Hyundai Genesis Coupe L4 2.0L - Downstream
For 2010-2012 Hyundai Santa Fe L4 2.4L - Downstream
For 2010-2013 Hyundai Sonata L4 2.4L Calif-ESV - Downstream
For 2014 Hyundai Sonata L4 2.4L - Downstream
For 2014 Hyundai Tucson L4 2.0L - Downstream
For 2011-2013 Hyundai Tucson L4 2.0L Calif-ESV - Downstream
For 2010-2013 Hyundai Tucson L4 2.4L Calif-ESV - Downstream
For 2014 Hyundai Tucson L4 2.4L - Downstream
For 2010-2013 Kia Forte L4 2.0L; 2.4L; Automatic Transmission; Calif-ESV - Downstream
For 2010-2013 Kia Forte Koup L4 2.0L; 2.4L; Automatic Transmission; Calif-ESV - Downstream
For 2011-2013 Kia Optima L4 2.4L Calif-ESV - Center
For 2014 Kia Optima L4 2.4L - Downstream
For 2011-2014 Kia Sorento L4 2.4L - Downstream
For 2011-2013 Kia Sportage L4 2.4L Calif-ESV - Downstream
For 2014 Kia Sportage L4 2.4L - Downstream
Part Included:
1x sensor