Deep 3D-printed base/junction box for Ubiquiti UniFi Protect turret cameras, with a 20mm hole for conduit or gland entry.

• Confirmed fit: UniFi Protect G5 Turret Ultra and G6 Turret cameras
• Should also fit the UniFi Protect AI Turret, but this has not been tested
• Deep profile, plenty of room to fit the weatherproof RJ45 connector supplied with the camera (this must be used)
• 1x 20mm hole on the side/bottom for conduit entry or a cable gland (gland/adapter not included; a female conduit adapter is recommended when using conduit)
• Printed in ASA plastic for UV and weather resistance
• Available in black or white to match the camera
• This is a third-party 3D-printed accessory, not an official Ubiquiti product

Other conduit configurations available on request: dual 20mm side entry (conduit in and out), dual 20mm 90° entry (conduit in the bottom, out the side), and 20mm rear entry with no side holes. Please message before buying if you need one of these instead of the single side-entry version shown.

Condition: New, 3D printed to order. As with all 3D-printed items, appearance may vary slightly between units. The base itself is not watertight, but this isn't required as the camera's cable connector is already waterproof. Note that the cable exiting the connector fits closely inside the base, as the base is the same diameter as the camera.

Included: Junction box base, top plate and mounting screws to fix the camera to the base. Cable gland/conduit adapter and camera not included.

Collection & Payment: Collection or postage available from Chesterfield. No returns accepted.