These 3D printed adapters attach onto your ESS Crossbow glasses and allows you to use your Novritsch or DIY anti fog Systems to consistently keep your glasses clear of fog / water droplets.
These spigots / bends are a snug fit inside the adapter body but for a more secure and permanent solution a drop of adhesive like superglue can be used to permanently attach the spigots in place. Sometimes leaving the bends unglued allow for more adjustment. I would recommend something less permanent like hot glue for these as it will allow for adjustment in the future.
The main adapter body can then be slid onto your glasses and snugged tight using a 1.5mm Allen key(not supplied)
(These Clips have a small ramps on the lower side of the clips slots which helps them secure properly, Make sure you're fitting them the correct way with the low point of the ramp facing towards the lenses and the high side facing towards the rear of the arms) I would suggest dry fitting the clips to ensure you're installing them the correct way.
DO NOT OVER TIGHTEN / FORCE THE MOUNTS ON. it doesn't need much to be secure.
Depending on where you want the bends to sit you may need to remove the bends when storing the glasses. Some customers sand their bends to get the fitment perfect.
The kit comes with 8mm spigot x4 6mm spigot x4 bends x2
Any more information please don't hesitate to ask.