HH-66 Thinner For H66 Adhesive; 128 Fluid Ounce 1 Gallon Can

Our HH-66 Thinner is designed primarily for use with HH-66 Vinyl Cement.This solvent-based thinner reactivates dried HH-66 Vinyl Cement or removes unwanted HH-66 from surfaces. You also can use HH-66 Thinner to clean brushes rollers spray guns and other types of applicators. Since HH-66 Thinner is flammable it should be used in a well-ventilated area. Handle empty containers with care as any residual solvent is flammable.When To Use HH-66 ThinnerIf Your Coat of HH-66 Vinyl Cement is No Longer Tacky: Use a brush or roller to apply a light layer of the appropriate HH-66 Thinner directly to the application. Bond the pieces together as per the adhesive directions.If Your Can of HH-66 Vinyl Cement Has Thickened in the Container: Add up to 20% HH-66 Thinner until the original consistency is reached. Mix until evenly dispersed.To Clean HH-66 Vinyl Cement from Brushes Rollers Spray Guns: Follow the manufacturers recommended cleaning procedure. It is recommended to clean the applicator immediately after use. HH-66 Thinner is flammable and should be used in a well-ventilated area. Handle empty containers with care as residual solvent is flammable.If The HH-66 Cement is Too Thick for your Application: Add HH-66 Thinner as needed (up to 20% thinner). Mix until evenly dispersed. Over-dilution can cause loss of bond strength. A second application may be required to achieve the appropriate coverage for a good bond.To Spray HH-66 Vinyl Cement Thinner Can Be Used to Dilute for Spraying: Usefulness depends on the sprayer and application. It is not recommended to use more than 20% thinner for spraying. With diluted adhesive a second application may be required to achieve the appropriate coverage for a good bond.