2. The machine is for indoor use only. Do not use outdoors or for other purposes.

3. To prevent electric shock and other hazards, unplug the power adapter when the machine is not in use.

4. Before cleaning the machine, you must first turn off the machine's power switch, unplug the power adapter, and operate carefully to prevent injury hazards!

5. Do not rinse the machine with water jets. Do not immerse the machine in water for cleaning.

6. The blades on the cutter head are extremely sharp. Before installing or removing the cutter head, you must first turn off the machine's power switch, unplug the power adapter, and operate carefully. The cutter head can be removed from the machine and rinsed separately with water, but be careful not to touch the sharp blade edges during installation or removal!

7. Do not put hands into the cutting area while the machine is operating.
    Do not adjust the cutting thickness while the machine is running.
    Do not put hands into the machine's discharge outlet, otherwise blade injury hazards may occur!

8. The machine is only suitable for cutting fruits, vegetables, etc. Do not use it to cut frozen food, hard foods (shells, pits, nuts, sugarcane, etc.), meat or meat products, bones, tough skins, or other hard raw materials.

2. Simple Operation: The operation is easy and convenient, and the press rod can be easily pressed.

3. Height Adjustability: The cutting height can be freely adjusted according to the food size, and well meets different height requirements of various food ingredients.

4. High Efficiency: The cutting efficiency is higher, the cutting size is uniform, the follow-up screening workload is greatly reduced, and the time and labor cost are effectively reduced.
　

Operation Handle

The operation handle is made of stainless steel materials, is not prone to deformation or looseness and has a long service life. It is comfortable to touch and saves labor during operation.
　

Cutting Module

The stainless steel cutter is sharp and durable, resistant to corrosion and easy to clean. The cutting thickness can be precisely adjusted within the range of 3-10mm, and the cutting effect is better.
　

Lock Knob

The lock knob is designed for freely adjusting and locking the height, the operation handle and the cutter head base can be effectively locked, and locking and unlocking are easy and effortless.
　

Adapter

The adapter is provided to support the wide voltage range of AC 110V-220V, ensuring stable power supply, and avoiding the poor cutting effect, motor overheating or short service life caused by unstable voltage.
　

1. Ensure the machine is stopped before placing food.

2. Press the press arm down until the food can be placed. Insert the food vertically onto the center tube of the cutter head. Try to insert the center of the food on the tube and keep the food vertical. Correct food placement ensures the best cutting result and reduces food fragments.

3. Slowly reduce the downward pressure on the press arm. The cutter head will automatically rebound and move upward until the food to be cut is gripped by the claw pieces. At this point, you can release the press arm.

4. After the food is placed and clamped, do not touch the cutter head. Confirm everything is correct, and then turn on the power switch. During cutting, the cutter head will gradually move upward. Do not touch the cutter head or any moving parts of the machine while it is operating.

5. After cutting is completed, press the press arm down again. The leftover end piece of food will remain on the cutter head. Remove the leftover piece and repeat the above operations.

Note: After each cutting operation, you must check whether the small blade on the cutter head is not accidentally damaged or missing. If yes, be sure to discard all cut food to ensure food safety.

Warning: Do not place food while the machine is running. Do not touch the cutter head area while the machine is cutting. When placing food, hold the press arm firmly to prevent accidental injury hazards!