E-bike controller X032-AA061, for use with 5S communication protocol instruments.

◆Invisible soft/hard start:

             Invisible soft/hard start. Squeeze the brake, turn the handle to the end, power up and wait 3 seconds - a soft start (default hard start) with memory, repeat the above operation again to switch to hard start.

◆Invisible single/double Hall booster:

            Invisible single/double hall booster. Squeeze the brake, power up, turn the turnbuckle three times - Dual Hall Boost (default single Hall Boost) with memory, repeat the operation again to switch.

Note: Only match 3-wire power assist sensor.

◆Under voltage protection:

            When the battery voltage bottoms out to the under-voltage value of the controller, it stops output automatically to protect the battery in time and prevent the battery pack from being damaged by over-discharge.

◆ Power-on anti-flying and running anti-flying:

           Prevent the controller from powering up due to line or turntable failure causing flying phenomenon, improve the safety of using the vehicle.

◆ MOS tube short circuit protection:

           Automatically detect MOS tube faults during power-up to prevent damage to other MOS tubes due to serial short-circuiting.

◆High temperature protection:

           When the controller's own temperature is too high, it automatically reduces the output current or stops the output

◆ Rotation protection:

           When the motor is blocked, the control caps automatically current limiting, blocked when the 2S catty cut off the circuit, timely protection of the motor and the controller.

Specification:

Type：X032-AA061

Weight: 180g

Current: 16A

Rated Voltage: 36V

Size: L92mm W50mm H29mm