Outboard Ignition Coil CDM Module for Mercury MerCruiser 114-7509 827509T7 4 Pin

Description:
Condition: Brand New & High Quality CDM Ignition Coil, 100% Tested before shipping to ensure product safety, stability and durability.
Part Number: 114-7509, 827509A1, 827509A3, 827509A4, 827509A7, 827509A8, 827509A9, 827509T 7, 9-23202, AMW- 3454
Compatible with Mercury (1996-2007 (30-300HP);Compatible with Force (1996-1999 (40,50,75,90 & 120HP)
OE replacement Mercury/Mariner Ignition CDM Module. Engine 4 Pin
Easy to install, just Plug-and-play, Direct replace your vehicle’s original factory component.We provide 100% perfect customer service,Any questions please sent email to us.

 

Compatibility:    
Fits 30 HP 2 cylinder engines from 1996 to 2006 with serial number range 0G380075-0T979999
Fits 30 HP 3 cylinder engines from 1998 to 2001 with serial number range 0G590000-0T999999
Fits 40 HP 2 cylinder engines from 1996 to 2005 with serial number range 0G380075-0T999999
Fits 100 HP 4 cylinder engines from 1996 to 2000 with serial number range 0G438000-0G965520
Fits 200 HP 6 cylinder engines from 2000 to 2005 with serial number range 0G960500-1B226999


Part Number:
114-7509
827509A3
827509A4
827509A7
827509A8
827509A9
827509A10
827509T7

 

How to install ignition CDM module 114-7509 ?
1. Disconnect and clean all engine and battery ground wires
2. Disconnect the old CDM Module and remove the high tension coil wire from the spark plug
3. Unbolt and remove the old CDM Module. (Note the direction of the spark plug wire)
4. Check for dc voltage on the kill (stop) wires (usually black/Yellow) with the key switch in the on and off position.
5. Apply a slight amount of dielectric grease to the seal area of the wire connector from the engine harness
6. Apply a slight amount of dielectric grease to the outside of the new spark plug wire and thread the spark plug wire into the new CDM Mod
7. Bolt the new CDM Module onto the engine(orient the new CDM Module so that the spark plug wire is pointed in the same direction as the original)
8. Plug in the connector from the wire harness into the new CDM Module and connect the spark plug wire to the spark plug


What You Get:
1PCS CDM Ignition Coil 

 

Note:
1.If you has any problem, please feel free to contact us.
2.Please let us know before you send us the neutral/negative feedback that wont help to finish the issues. And I will definitely try my best to provide the best solutions which would meet your satisfactory.