Unobtrusive IMac 27” Broken Stand Fix Solution - 3D Printed - Black

This is a strong, 3D printed part to prevent 27” iMac screen from pivoting down. This allows the screen to be set in any position (facing anywhere from up to down- you can set where) and not move from its place.This can be usedinstead of paying for a costly replacement from apple, or for piece of mind to prevent screen from moving once locked in place, has room to run the cable through as well.

Package Contents:

1x Main Screen Holder

2x Locking Nuts (one for either side)

Installation:

1) Undo the first nut and remove.

2) Place main holder with the remaining nut through the hole in Mac stand with the screw thread poking through the other side of the hole towards the back of the Mac .

3) Install the nut removed earlier and adjust to desired position.

4) Thread Mac cable through hole

Please note: IMac not included this is just the stand! and due to the nature of 3D printing surface finish may vary.