Irontite Ceramic Block Seal Motor Seal 455ml 16oz US

Ceramic Motor Seal a ceramic engine block sealer is a to coat all areas of the inside of your engine cooling system. It’s important to start with a clean and free of debris system. For this reason it is recommended that you use a flush to fully clean your cooling system before treating with Ceramic Motor Seal.

Be sure to read and follow all the instructions carefully. And once you have completed the application of Ceramic Motor Seal we recommend using Irontite All Weather Seal with your normal Anti-Freeze mixture. All Weather Seal will prevent any future leaks.

INSTRUCTIONS

Warning: Ceramic Seal is not compatible with anti-freeze. All anti-freeze must be removed before using. Use a flush to “clean” your cooling system and after flushing, rinse your system with water at least once.

One bottle treats up to 6 gallons. HD trucks may require additional bottles and smaller systems may use less than the entire bottle.

CAUTION: ALWAYS ALLOW ENGINE TO COOL so radiator cap or top radiator hose can be removed safely.

** Raw Ceramic Seal will damage painted and chrome surfaces permanently. **

1. Drain and flush coolant system. (We recommend Industrial-Strength .) Rinse system with water at least once.
2. If vehicle does not have a pressurized radiator cap, remove top radiator hose and fill water and product directly into the radiator from the top hose.
3. Shake Bottle well. If bottle has sediment in the bottom be sure to get it mixed up before adding to your system. (no hard lumps) If there is more than ¾” of sediment that will not mix, do not use.
4. Fill coolant system with clean water and the appropriate amount of Ceramic Seal based on your cooling system capacity. (1 bottle = 6 gallon system capacity. 3 gallon system capacity = ½ bottle)
5. Ceramic Seal ** WILL PERMINANTLY ** stain paint and/or chrome surfaces. Wipe any excess from cap and radiator neck.
6. Replace radiator cap or re-attach radiator hose and tighten hose clamp.
7. Completely fill system with water, including overflow tank. Run engine and check level again.
8. Run engine on fast idle for a minimum of 1 hour, or vehicle may be driven up to two days. Then drain completely and rinse/flush with water. The longer you run the thicker the seal coat will be.
9. Leave coolant system open and empty for 12 hours minimum to let Ceramic Seal air dry and cure. A basic hand held hair dryer can be used to speed up and/or improve drying process.
10. After 12 hours or more of air drying, fill with normal coolant mixture