Fitments:

Starter solenoid pigtail connector harness plug For 2012-2018 JEEP WRANGLER AND JK,  V6, 3.6L. Please note that it will not fit the 2.0L Engine.

Specifications: 

Brand new, Unused

Branded: hozlyblogors

Type: Starter Pigtail Connector Wire Harness Plug

Features: Use high temperature wire insulation, enhanced thermal protection.

Material: Silicone Rubber,Glass Fiber Braid

Replace Part Number: H7155,19300471,PT2974

Package Included: 

 1 x Starter pigtail connector harness plug

Notes: 

The replacement harness is spliced into the vehicle's existing harness by crimping it in place with a butt connector and crimping tool (not included). 

Please be sure to use sufficient pressure with the crimping tool to ensure tight crimps on the ends of both wires being crimped. 

To verify that the new pigtail harness has been properly attached, use a FAIR amount of force to pull on both sides of the butt connector simultaneously. (USE ABOUT THE SAME AMOUNT OF FORCE AS YOU IMPOSE WHEN TYING YOUR SHOELACES).  The newly crimped ends should NOT give any slack at all.

If the wire(s) begin to pull out away from the butt connector, cut the butt connector off and repeat the process with a new butt connector and make sure to impose sufficient force on the new butt connector with the crimping tool. 

Purchase Instructions：

The package contains the products shown in the pictures. 

Please check the product, appearance, part number and matching model carefully before purchasing. 

If you are not sure, please consult us before confirming the purchase.