The dimensions of the bottom of the handle is approx. 6" x 2"
Don't get this part confused with the very similar part, the 2PYR Handle Support, which is about 4 3/4'' x 1 7/8"

The 2PYR can be bought here: https://www.ebay.com/itm/374018270676

• Miter handle support 2VPR holds the miter handle in place on the table.
• It is 3D printed out of PETG plastic, which is strong.

Please note: The following is just a standard disclaimer for clarity and transparency.

DISCLAIMER: This piece is an aftermarket replacement for a Craftsman miter saw. It is not manufactured or endorsed by Craftsman or Sears. While it should function when properly installed, it has not been long-term tested and may not meet current safety standards. Buyer is solely responsible for verifying compatibility, safe installation, and safe operation. Seller is not responsible for injury, damage, or loss related to its use.