Tormek T-8:  Get Top Results with the most advanced water cooled sharpening system available: the T-8 Sharpening System from Tormek!


The T-8 wet stone sharpening system is rated for continuous use, has a vast array of specialty jigs available so you can quickly and easily sharpen virtually any tool in your house, backyard shed or workshop, and maximizes precision thanks to a revolutionary fully cast housing frame which guarantees minimal play for the Universal Support.

Watch two videos on the T-8 at Advanced Machinery: search for Advanced Machinery T-8.

The heart of the T-8 is the Tormek SG-250 10" x 2" grinding wheel turning at a slow 90 rpm through water. The water acts as a lubricant for faster grinding while it continuously cools the tool edge to prevent "bluing" the metal edges you are sharpening. After grinding, the genuine leather honing wheel gently removes the burr and hones the edge to razor sharpness.          
          
                   
  • Cast Zinc Frame for maximum precision                
    •                
  • Cast Zinc internal Drive Wheel with proprietary rubber compound                
    •                
  • Stainless steel main shaft with Ezylock for quick stone change                
    •                
  • Micro adjust nut with scale on Universal Support with Acme thread
    •                
  • Leather Honing Wheel - Power cord exit under the honing wheel
    •                
  • Horizontal Base for Universal Support cast in Housing
    •                
  • Advanced Water Trough with screw lift, magnet and scrape
    •                
  • NEW SE-77 Square Edge Jig to sharpen chisels and plane blades more easily than ever                
    •                
  • 115 volt, 200W, 60Hz, 1.5 Amp Motor (other voltages NOT AVAILABLE.) WARNING: This machine operates at 115 Volts. Please be aware that if you plan to use this product at 220 – 240V, you will burn out the motor and damage the machine.             
    •                
  • 39 lb weight                
    •                
  • 7 year warranty
    •                                                                                                                                                                                                          
Square Edge Jig SE-77
The new SE-77 Square Edge Jig, included with the T-8, changes the task of grinding tools square from tricky to foolproof. It references from the flat side of the tool for unparalleled ease in tool mounting. It also has travel limit stops that prevent you from running the tool off the edge and scraping a knuckle. The SE-77 Square Edge Jig is a further development of the SE‑76 jig. It has been provided with an adjustable side that can be set with the help of two smaller knobs, which allows fine tuning if needed. This can be required if the tool is not exactly square to the stone, is very narrow or if the steel is slightly twisted.
 
The T-8 System also includes the Angle Master, Honing Compound , Stone Grader , Diamond Truing Tool , Handbook and Instructional DVD.

Please Note: Free shipping applies to shipping within the 48 States ONLY. Please contact us for shipping costs outside the 48 States.