Fitment Notes:
24 Volt Application - Kit sold in 12 volt configuration, for 24 volt application, you will need to purchase 2 x 24 volt relays.
Air Temperature Application - It senses air temperature as it passes through the radiator and has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF).        The Temperature Sensor is placed in the radiator fin section as close to the hot coolant inlet as possible, no need to cut hoses or can be placed directly into the coolant system.
Water / Coolant Application - The 0444 sensor can also be placed directly into the coolant system.        You will need to use a Temperature Sensor Adaptor Kit to assist with this type of fitment.
it will not vary the speed of the pump in response to engine temperature but rather turn the pump on and off at your set temperature.
The sensor, a Temperature Probe (Air or Coolant Fitment) senses air temperature as it passes through the radiator with the sensor placed in the radiator fin section or the sensor can also be placed directly into the coolant system in combination with a Temperature Sensor Adaptor Kit.

Sensor Wire length:
142cm in total (Wire from switch 112cm plus sensor connector 30cm)
Post 15-Dec-2021 = 320cm total (Wire from switch 290cm plus sensor connector 30cm)
*The sensor wire has been increased to 320cm from the 15-Dec-2021, batch date 2021
The switch can run 1 or 2 fans and be used for 12 or 24 volt applications.        It has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF) which can show Centigrade or Fahrenheit.
Fan #1 will start once the temperature reaches the set temperature.
Fan #2 (if applicable) will start operation 10 seconds after fan #1 starts.
The fan/s will operate until the temperature falls by 5°C below the set temperature.
IP66 Rated:
Protected from total dust ingress
Protected from high pressure water jets from any direction, limited ingress protection
Not waterproof
Integrated electrical noise filter for improved compatibility and reliability in older vehicles that produce high levels of electrical interference and noise

Specifications:
Fan Switch Kit
Part Number: 0444
Max voltage: 12 to 27V (For 24V, relays need to be changed, not supplied in kit)
Max current: Rated to 30 amps per Fan (Maximum 40amp per Fan) Unit comes with 2 x 30 amp fuses and 2 x 40 amp relays
Relay setup: Dual relay
Sensor Wire length: 142cm in total (Wire from switch 112cm plus sensor connector 30cm)
Speed: Single speed, 10 second delay to start up the second fan
Applications: Suitable for single and dual fan applications
Screen Display: LED digital temp display, actual temp + set temp
Temp Display: Centigrade or Fahrenheit
Temp settings: 40°c to 110°c  (104°F to 230°F)
Temp setting: Push Button
Circuit type: Pre-programmed micro controller
Output wires: Batt + Batt - IGN, AC Clutch, Fan #1, Fan #2 Thermistor Probe
Dimensions: 95mm x 65mm x 56mm

Kit Inclusions:

1x Digital Fan Switch IP66 Mounting Kit



Note:

Accessories random color based on physical, order need to be careful!

please make sure it will fit your machine before purchasing it.
Please check pictures for more details.